Quick Guide

6
3.1 Terminal Block Connector Pinout
To install the 3-pin (WRG-500-4PV/WRG-500-4P) and 2-pin (WRG-500) Terminal
Block Connector on the Industrial Router, simply follow the following steps:
Step 1: Insert positive DC power wire into V+, negative DC power wire into V-,
and grounding wire into Ground.
V+
V
-
Ground
V+
V
-
3-pin 2-pin
Step 2: Tighten the wire-clamp screws for preventing the wires from loosening
and plug them into the Wall-mount Gigabit Ethernet Router
Note
1. The wire gauge should be in the range from 12 to 24 AWG.
2. The device must be grounded.
3.2 DC Power Jack
The WGR-500-4P/WGR-500-4P requires DC 48V~56V power input and the
WGR-500 requires DC 9~48V power input. Should you have the issue of power
connection, please contact your local sales representative.
2.1mm
DC Receptacle: 2.1mm
Its DC receptacle is 2.1mm wide that conforms to the WGR-500 series
with DC jack's 2.1mm central post. Do not install any improper unit.