User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. FAQs
- FAQ 1. What can I do if I forgot my wireless password?
- FAQ 2. What can I do if I forgot my login password of the web management page?
- FAQ 3. I cannot log into the router’s web management page, what can I do?
- FAQ 4. I cannot access the Internet even though the configuration is finished. What can I do?
- FAQ 5. I cannot find my wireless network or I cannot connect the wireless network
- FAQ 6. How to switch the working mode of the router?
- FAQ 7. How to troubleshoot wireless relay failure
- FAQ 8. How to place routers for best signal/coverage
- FAQ 9. How to troubleshoot W-Fi Mesh networking failure
- Chapter 7. Quick Connection to a Wireless Network
- Appendix A: Specifications
User Manual of WDRT-1800AX
-51-
Router
5.1.20 LAN settings
Figure 5-34 LAN settings
Object
Description
IP Address
Router’s LAN IP.
The default is 192.168.1.1. You can change it according to your needs.
Mask
Router’s LAN subnet mask.
DHCP
Click the button to enable or disable Router DHCP Server function.
Starting IP / Ending IP
Configure the IP address interval that allocated to the terminal. The
address interval must be on
the same network segment as the
management IP address of the Router.
Lease Time
Select the time for using one assigned IP from the dropdown list. After
the lease time, the AP automatically assigns new IP addresses to all
connected computers.
DNS1
Set main DNS for internet wan connection(If not filled, the gateway
address will be used as the DNS address)
DNS2
Set second DNS for internet wan connection(If not filled, the gateway
address will be used as the DNS address)