User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. FAQs
- FAQ 1. What can I do if I forgot my wireless password?
- FAQ 2. What can I do if I forgot my login password of the web management page?
- FAQ 3. I cannot log into the router’s web management page, what can I do?
- FAQ 4. I cannot access the Internet even though the configuration is finished. What can I do?
- FAQ 5. I cannot find my wireless network or I cannot connect the wireless network
- FAQ 6. How to switch the working mode of the router?
- FAQ 7. How to troubleshoot wireless relay failure
- FAQ 8. How to place routers for best signal/coverage
- FAQ 9. How to troubleshoot W-Fi Mesh networking failure
- Chapter 7. Quick Connection to a Wireless Network
- Appendix A: Specifications
User Manual of WDRT-1800AX
-37-
5.1.7 WISP (Wireless Relay)
Turn on WISP and select the operation mode you need, and then press the "Refresh" button to scan the Wi-Fi
that you need to be relayed. After successful, the router will restart. After the router restarts, some functions
cannot be used. If you want to use all the functions, please switch to the router mode. Please refer to the FAQs
on how to switch to the router mode.
Here’re two modes to choose from:
WISP
The upper-level router will only display your routing information, and the devices under your router will not
display it.
The IP of the connected device is assigned by your router, and the two network segments are different.
Figure 5-15 WISP
Repeater
The upper-level router will not only display your routing information, but also the devices connected to your
router will display.
The IP of the connected device is allocated by the other party's router, and the network segment is the same.