User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. FAQs
- FAQ 1. What can I do if I forgot my wireless password?
- FAQ 2. What can I do if I forgot my login password of the web management page?
- FAQ 3. I cannot log into the router’s web management page, what can I do?
- FAQ 4. I cannot access the Internet even though the configuration is finished. What can I do?
- FAQ 5. I cannot find my wireless network or I cannot connect the wireless network
- FAQ 6. How to switch the working mode of the router?
- FAQ 7. How to troubleshoot wireless relay failure
- FAQ 8. How to place routers for best signal/coverage
- FAQ 9. How to troubleshoot W-Fi Mesh networking failure
- Chapter 7. Quick Connection to a Wireless Network
- Appendix A: Specifications
User Manual of WDRT-1800AX
-28-
5.1.2 Mode
In this part, you can check your current Internet connection settings. You can also modify the settings according
to the service information provided by your ISP.
Dynamic
Choose “Dynamic IP (DHCP)” and the router will automatically obtain IP addresses, subnet masks and gateway
addresses from your ISP.
Figure 5-5 Dynamic IP
Static IP
If your ISP offers you with static IP Internet connection type, select “Static IP " and then enter IP address, subnet
mask, primary DNS and secondary DNS information provided by your ISP in the corresponding fields.
Figure 5-6 Static IP