User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. FAQs
- FAQ 1. What can I do if I forgot my wireless password?
- FAQ 2. What can I do if I forgot my login password of the web management page?
- FAQ 3. I cannot log into the router’s web management page, what can I do?
- FAQ 4. I cannot access the Internet even though the configuration is finished. What can I do?
- FAQ 5. I cannot find my wireless network or I cannot connect the wireless network
- FAQ 6. How to switch the working mode of the router?
- FAQ 7. How to troubleshoot wireless relay failure
- FAQ 8. How to place routers for best signal/coverage
- FAQ 9. How to troubleshoot W-Fi Mesh networking failure
- Chapter 7. Quick Connection to a Wireless Network
- Appendix A: Specifications
User Manual of WDRT-1800AX
-27-
Figure 5-2 Network connection state
Wizard setting
When the device that has just been shipped from the factory enters the web management, you can go to the
Wizard setting on the management page.
Figure 5-3 Wizard setting
If you have installed PPP software such as WinPoET (from Earthlink) or Enternet
(from PacBell), then you have PPPoE. Select Yes. After selecting Yes and
configuring your router, you will not need to run the
PPP software on your PC to
connect to the Internet.
5.1.1 WAN port connection status
If there is a WAN port connected, it will show "Inserted cable", otherwise will be "Un insert cable".
Figure 5-4 Connection status