User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the Router
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the Router
- Chapter 6. FAQs
- FAQ 1. What can I do if I forgot my wireless password?
- FAQ 2. What can I do if I forgot my login password of the web management page?
- FAQ 3. I cannot log into the router’s web management page, what can I do?
- FAQ 4. I cannot access the Internet even though the configuration is finished. What can I do?
- FAQ 5. I cannot find my wireless network or I cannot connect the wireless network
- FAQ 6. How to switch the working mode of the router?
- FAQ 7. How to troubleshoot wireless relay failure
- FAQ 8. How to place routers for best signal/coverage
- FAQ 9. How to troubleshoot W-Fi Mesh networking failure
- Chapter 7. Quick Connection to a Wireless Network
- Appendix A: Specifications
User Manual of WDRT-1800AX
-19-
Figure 4-4 Obtain an IP Address Automatically
4.1.2 Configuring the IP Address Manually
Summary:
Set up the TCP/IP Protocol for your PC.
Configure the network parameters. The IP address is 192.168.1.xxx ("xxx" is any number from 2 to
254), Subnet Mask is 255.255.255.0, and Gateway is 192.168.1.1 (The Router's default IP address)
If you are sure the DHCP server of Wireless Router is disabled, you can configure the IP address manually. The
IP address of your PC should be 192.168.1.xxx (the same subnet of the IP address of the Wireless Router, and
"xxx" is any number from 2 to 254), Subnet Mask is 255.255.255.0, and the Gateway is 192.168.1.1 (The default
IP address of the Wireless Router)
1) Continue the settings from the last figure. Select Use the following IP address radio button.
2) If the LAN IP address of the Wireless Router is 192.168.1.1, enter IP address 192.168.1.x (x is from 2 to
254), and Subnet mask 255.255.255.0.
3) Enter the LAN IP address of the Wireless Router (the default IP is 192.168.1.1) into the default gateway
field.
4) Select Use the following DNS server addresses radio button. In the preferred DNS Server field, you can
enter the DNS server IP address provided by your local ISP. Then click OK to save your settings.