User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Connecting to the AP
- Chapter 3. Quick Installation Guide
- Chapter 4. Configuring the AP
- Chapter 5. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: FAQs
- Appendix C: Troubleshooting
- Appendix D: Glossary
User Manual of WDAP-C7210E_WDAP-W1200E_WDAP-850AC
-105-
Step 5. Click “Next” to finish the setting.
Step 6. Click “Repeater Information” to check connection status.
【
Remark
】
If the signal was too high or too low that will effects the connection quality, please adjust the
Tx power from web GUI or antenna to get best value about -60~-65 dBm.
Wireless Signal Status Signal (dBm)
Too Strong >-60dBm
Strong -61dBm~-70 dBm
Good -71dBm~-80 dBm
Bad -81dBm~-90 dBm
Very Bad <-90dBm