Quick Guide

- 1 -
- 2 -
- 3 -
- 4 -
- 5 -
- 6 -
- 7 -
- 8 -
1. Package Contents
Thank you for choosing PLANET WDAP-C7210E. Before installing the AP,
please verify the contents inside the package box.
The WDAP-C7210E should contain the following items in the package:
WDAP-C7210E x 1 Quick Guide x 1
Ethernet Cable x 1 Mounting Kit
Note
If there is any item missing or damaged, please contact
the seller immediately.
3. Hardware Installation
Step 1: Take the mounting bracket, put it on the target place by
aligning the holes and x it with the supplied screws.
Step 3: After you enter into the Web User Interface, go to Advanced
to congure your wireless network.
Step 4: Once the basic conguration of the WDAP-C7210E is done,
click the “Apply” button to make the change take eect.
4.WiredNetworkConguration
(Windows 7 and Windows 10)
A computer with wired Ethernet connection is required for the rst-time
conguration of the wireless AP.
1. Click the “Start” button located at the lower-left corner of your
computer.
2. Click “Control Panel”.
3. Double-click the “Network and Sharing Center” icon.
4. Click “Change adapter settings”.
5. Double-click “Local Area Connection”.
6. Select “Internet Protocol Version 4 (TCP/IPv4)” and click
“Properties”.
7. Select “Use the following IP address” and then click the “OK”
button twice to save the conguration. For example, the default IP
address of the WDAP-C7210E is 192.168.1.253 and the router is
192.168.1.254. You may choose from 192.168.1.1 to 192.168.1.252.
2.PhysicalIntroduction
Front Panel
Power
(Red)
SYS
(Blue/Green)
Rear Panel
12V DC IN (5.5 x 2.1mm)
LED
WAN/PoE IN
Reset Button
LAN
Step 2: Load the device into the mounting bracket, and be sure the
device is mated with xed screws. Then, lock the device in
position and plug the Ethernet cable into the WDAP-C7210E.
Step 3: Plug the other end of the Ethernet cable into the PoE switch.
5. Entering into the Web Management
Default IP Address: 192.168.1.253
Default Password: admin
Default SSID (2.4GHz): Planet _2.4G
Default SSID (5GHz): Planet _5G
Step 1: The Web management allows you to access and manage the
wireless AP easily. Launch the Web browser and enter the
default IP address http://192.168.1.253.
Step 2: When the login window pops up, please enter password. The
default password is “admin”. Then click the LOGIN button to
continue.
For security reasons, it is recommended to change the password at the
rst login and memorize it.
6. Wireless Network Connection
Step 1: Right-click on the network icon displayed in the system tray.
Step 2: Highlight the wireless network (SSID) to connect and click the
[Connect] button.
Step 3: Enter the encryption key of the WDAP-C7210E if necessary.
You have already nished the conguration of the WDAP-C7210E. Now
you can use your smart phone, tablet, laptop, or any other Wi-Fi device
to connect with it wirelessly and start surng the internet.

Summary of content (2 pages)