User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Physical Descriptions
- Chapter 3. Preparation
- Chapter 4. Web-based Management
- Chapter 5. Quick Connection to a Wireless Network
- Appendix A: DDNS Application
- Appendix B: FAQs
- Appendix C: Troubleshooting
- Appendix D: Glossary
- EC Declaration of Conformity
User Manual of WDAP-C1800AX &WDAP-1800AX &WDAP-W1800AXU
- 73 -
4.2.9 DHCP
The DHCP service allows you to control the IP address configuration of all your network devices. When
a client (host or other device such as networked printer, etc.) joins your network it will automatically get
a valid IP address from a range of addresses and other settings from the DHCP service. The client
must be configured to use DHCP; this is something called "automatic network configuration" and is
often the default setting. The setup is shown in Figure 4-35.
Figure 4-35: DHCP
Object
Description
DHCP Service
By default, the DHCP Server is enabled, meaning the router will
assign IP addresses to the DHCP clients automatically.
If user needs to disable the function, please set it as disable.
Start IP Address
By default, the start IP address is 192.168.1.100.
Please do not set it to the same IP address of the router.
Maximum DHCP Users
By default, the maximum DHCP users are 101, meaning the router
will provide DHCP client with IP address from 192.168.1.100 to
192.168.1.200 when the start IP address is 192.168.1.100.
DNS Server
By default, it is set as Automatically, and the DNS server is the
router’s LAN IP address.
If user needs to use specific DNS server, please set it as Manually,
and then input a specific DNS server.