User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Physical Descriptions
- Chapter 3. Preparation
- Chapter 4. Web-based Management
- Chapter 5. Quick Connection to a Wireless Network
- Appendix A: DDNS Application
- Appendix B: FAQs
- Appendix C: Troubleshooting
- Appendix D: Glossary
- EC Declaration of Conformity
User Manual of WDAP-C1800AX &WDAP-1800AX &WDAP-W1800AXU
- 119 -
Step 1. Use static IP in the PCs that are connected with AP-1(Site-1) and AP-2(Site-2). In this case,
Site-1 is “192.168.1.100”, and Site-2 is “192.168.1.200”.
Step 2. In AP-2, change the default IP to the same IP range but different from AP-1. In this case, the IP
is changed to 192.168.1.252.
Step 3. In AP-1, go to “Wizard” to configure it to AP Mode. In AP-2, configure it to Repeater Mode.
AP-1