User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the CPE
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the CPE
- Chapter 6. Quick Connection to a Wireless Network
- Appendix A: Planet Smart Discovery Utility
- Appendix B: FAQs
- Appendix C: Troubleshooting
- Appendix D: Glossary
User Manual of WBS-512AC
-67-
Step2. In AP-2, change the PtP switch to slave, the default IP is 192.168.1.100.
Step 3. In AP-1, go to “Wizard” to configure it to AP Mode. In AP-2, configure it to Repeater Mode.
AP-1
AP-2
Step 4. In AP-2, press Scan AP to search the AP-1. You can also enter the MAC address, SSID, encryption and
bandwidth if you know what they are.