User's Manual

5-Port 10/100/1000T VPN Security Router
VR-100
- 18 -
Step 1: Place your device on a hard flat surface, with the front panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the device with supplied screws attached to the
package. In the picture below, it shows how to attach brackets to one side of the device.
You must use the screws supplied with the mounting brackets. Damage caused to the
parts by using incorrect screws would invalidate the warranty.
Step 3: Secure the brackets tightly.
Step 4: Follow the same steps to attach the second bracket to the opposite side.
Step 5: After the brackets are attached to the device, use suitable screws to securely attach the
brackets to the rack, as shown in the picture below.
The width of the rack should be at least 453 mm.
Step 6: Proceed with Steps 4 and 5 in Section 2.2.1 Desktop Installation to connect the network cabling
and power on the device.