User's Manual

5-Port 10/100/1000T VPN Security Router
VR-100
- 17 -
2.2 Hardware Installation
2.2.1 Desktop Installation
To install the VR-100 on desktop, simply follow the following steps:
Step 1: Place the device on desktop.
Step 2: Keep enough ventilation space between the device and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions should
be under the specifications of the VR-100.
Step 3: Connect your device to hub / switch.
A. Connect one end of a standard network cable to the LAN port (port 1) of the device.
B. Connect the other end of the cable to the hub / switch.
The UTP Category 5, 5e or 6 network cabling with RJ45 tips is recommended.
Step 4: Connect your device to internet.
A. Connect one end of a standard network cable to the WAN port (port 5) of the device.
B. Connect the other end of the cable to the LAN port of ISP network device (such as a modem).
If there is only one line connected to the outer network in your network environment, it
is suggested that you use WAN port (port 5).
Step 5: Power on the device. When the device receives power, the Power LED should remain solid
Green.
2.2.2 Rack Mounting (optional)
If you need install the VR-100 in a 19-inch standard rack, please contact your dealer first and order the
accessories -- RKE-10B, a rack mounting kit not included in the package.
Please follow the instructions described below.
(The device shown on this chapter is just a representation of the said device.)