User's Manual
Table Of Contents
- 1 Overview
- 2 Appendix Table
- 3 Introduction to the User
- 4 Basic Function
- 5 Advance Function
- 6 Phone Settings
- 7 Web Configurations
- 8 Network >> Basic
- 8.1 Network >> Service Port
- 8.2 Network >> VPN
- 8.3 Network >> Advanced
- 8.4 Line >> SIP
- 8.5 Line >> SIP Hotspot
- 8.6 Line >> Dial Plan
- 8.7 Line >> Basic Settings
- 8.8 Phone settings >> Features
- 8.9 Phone settings >> Media Settings
- 8.10 Phone settings >> MCAST
- 8.11 Phone settings >> Action
- 8.12 Phone settings >> Time/Date
- 8.13 Phone settings >> Tone
- 8.14 Phone settings >> Advanced
- 8.15 Phonebook >> Contact
- 8.16 Phonebook >> Cloud phonebook
- 8.17 Phonebook >> Call List
- 8.18 Phonebook >> Web Dial
- 8.19 Phonebook >> Advanced
- 8.20 Call Log
- 8.21 Function Key >> Function Key
- 8.22 Function Key >> Softkey
- 8.23 Function Key >> Advanced
- 8.24 Application >> Manage Recording
- 8.25 Security >> Web Filter
- 8.26 Security >> Trust Certificates
- 8.27 Security >> Device Certificates
- 8.28 Security >> Firewall
- 8.29 Device Log >> Device Log
- 9 Trouble Shooting
63 / 122
Picture 75 - Enable SCA
After an account is configured and successfully registered, you can configure lines whose DSS Key is Shared
Call Appearance on the Function Key page to facilitate viewing the call status of the group. Each line key
represents a call appearance. Understand the call status by referring to 6.3 Appendix III –LED .
To facilitate private hold, configure keys whose DSS Key is Private Hold on the Function Key page. Pay
attention that the public hold key is the softkey-hold key during a call.
Picture 76 - Set Private Hold Function Key
Each phone registered with the BroadSoft server should be configured as above, then the SCA function
can be used.
2) LED Status
To facilitate viewing the call status of a group, configure the DSS Key as SCA. The following table describes
the LEDs of lines in different states.