User's Manual
Table Of Contents
- 1 Overview
- 2 Appendix Table
- 3 Introduction to the User
- 4 Basic Function
- 5 Advance Function
- 6 Phone Settings
- 7 Web Configurations
- 8 Network >> Basic
- 8.1 Network >> Service Port
- 8.2 Network >> VPN
- 8.3 Network >> Advanced
- 8.4 Line >> SIP
- 8.5 Line >> SIP Hotspot
- 8.6 Line >> Dial Plan
- 8.7 Line >> Basic Settings
- 8.8 Phone settings >> Features
- 8.9 Phone settings >> Media Settings
- 8.10 Phone settings >> MCAST
- 8.11 Phone settings >> Action
- 8.12 Phone settings >> Time/Date
- 8.13 Phone settings >> Tone
- 8.14 Phone settings >> Advanced
- 8.15 Phonebook >> Contact
- 8.16 Phonebook >> Cloud phonebook
- 8.17 Phonebook >> Call List
- 8.18 Phonebook >> Web Dial
- 8.19 Phonebook >> Advanced
- 8.20 Call Log
- 8.21 Function Key >> Function Key
- 8.22 Function Key >> Softkey
- 8.23 Function Key >> Advanced
- 8.24 Application >> Manage Recording
- 8.25 Security >> Web Filter
- 8.26 Security >> Trust Certificates
- 8.27 Security >> Device Certificates
- 8.28 Security >> Firewall
- 8.29 Device Log >> Device Log
- 9 Trouble Shooting
61 / 122
phone to receive an RTP stream from pre-configured multicast listening address without involving SIP
signaling. You can specify up to 10 multicast listening addresses.
Picture 72 - Multicast Settings Page
Table 11 - MCAST Parameters on Web
Parameters Description
Normal Call Priority Define the priority of the active call, 1 is the highest priority, 10 is the lowest.
Enable Page Priority
The voice call in progress shall take precedence over all incoming paging calls.
Name Listened multicast server name
Host:port Listened multicast server’s multicast IP address and port.
Multicast:
Go to web page of [Function Key] >> [Function Key] , select the type to multicast, set the multicast
address, and select the codec.
Click Apply.
Set up the name, host and port of the receiving multicast on the web page of [Phone Settings] >>
[MCAST].
Press the DSSKY of Multicast Key which you set.
Receive end will receive multicast call and play multicast automatically.
5.7 SCA
（
Shared Call Appearance
）
Users need the support of server end to use SCA function.
1) Configure on Phone
When registering with the BroadSoft server, a Phone can register the account created previously on
multiple terminals.