User's Manual

101 / 122
hands-free function to transfer the current call to a third party.
Attended Transfer on Onhook
Hang up the handle or press the hands-free button to realize the function
of attention
-transfer, which can transfer the current call to a third party.
Attended Transfer on
Conference Onhook
During a three-way call, hang up the handle and the remaining two
parties remain on the call.
Enable E.164
Please refer to e. 164 standard specification
Add dialing rules:
Picture 127 - Custom setting of dial - up rules
Table 21 - Dial - up rule configuration table
Parameters Description
Dial rule
There are two types of matching: Full Matching or Prefix Matching. In Full matching,
the entire phone number is entered and then mapped per the Dial Peer rules.
In prefix matching, only part of the number is entered followed by T. The mapping
with then take place whenever these digits are dialed. Prefix mode supports a
maximum of 30 digits.
Note: Two different special characters are used.
 x -- Matches any single digit that is dialed.
 [ ] -- Specifies a range of numbers to be matched. It may be a range, a list of ranges separated by
commas, or a list of digits.
Destination
Set Destination address. This is for IP direct.
Port Set the Signal port, and the default is 5060 for SIP.
Alias Set the Alias. This is the text to be added, replaced or deleted. It is an optional item.
Note: There are four types of aliases.
 all: xxx – xxx will replace the phone number.