User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface & Installa
- Chapter 3. Introduction to the Phone Use
- Chapter 4. IP Phone Setup
- Chapter 5. Using the Phone
- 5.1 Making Phone Calls
- 5.2 Make/Receive Second Call
- 5.3 Join/Split Two Calls (3-way Local Co
- 5.4 Call Transfer
- 5.5 Using Phonebook
- 5.6 Add/Edit/Delete Contact
- 5.7 Add/Edit/Delete Group
- 5.8 Browse and Add/Remove Contacts in Gr
- 5.9 Using Cloud Phonebook
- 5.10 Open Cloud Phonebook
- 5.11 Call Logs
- 5.12 Voice Message
- 5.13 Do-Not-Disturb
- 5.14 Auto-Answering
- 5.15 Call Forward
- Chapter 6. Phone Settings
- Chapter 7. Web Portal
- 7.1 Web Portal Authentication
- 7.2 Web Call
- 7.3 SYSTEM (Information)
- 7.4 SYSTEM (Account)
- 7.5 SYSTEM (Configurations)
- 7.6 SYSTEM (Upgrade)
- 7.7 SYSTEM (Auto Provision)
- 7.8 SYSTEM (Tools)
- 7.9 NETWORK (Basic)
- 7.10 NETWORK (Advanced)
- 7.11 NETWORK (VPN)
- 7.12 LINES (SIP)
- 7.13 LINES (Dial Peer)
- 7.14 LINES (Dial Plan)
- 7.15 LINES (Global Settings)
- 7.16 PHONE (Features)
- 7.17 PHONE (Audio)
- 7.18 PHONE (MCAST)
- 7.19 PHONE (Time/Date)
- 7.20 PHONE (Advanced)
- 7.21 PHONEBOOK (Contacts)
- 7.22 PHONEBOOK (Cloud Phonebook)
- 7.23 PHONEBOOK (Blacklist)
- 7.24 PHONEBOOK (Advanced)
- 7.25 CALL LOGS
- 7.26 FUNCTION KEY
- 7.27 FUNCTION KEY (Softkey)
- Chapter 8. Advanced Features
- Chapter 9. Troubleshooting
- Appendix I - Icon Illustration
- Appendix II - Text Input from Keypad
- Appendix III - LED Definition
Parameters Description
headset if the auto-answer or intercom is enabled.
7.18 PHONE (MCAST)
This feature allows user to make some kind of broadcast call to people who are in multicast group. User
can configure a multicast DSS Key on the phone, which allows user to send a Real-time Transport
Protocol (RTP) stream to the pre-configured multicast address(es) without involving SIP signaling. You
can also configure the phone to receive an RTP stream from pre-configured multicast listening
address(es) without involving SIP signaling. You can specify up to 10 multicast listening addresses.
Table 9 - MCAST Parameters on Web
Parameters Description
Normal Call Priority Define the priority of the active call; 1 is the highest priority, 10 is the lowest.
Enable Page Priority
The voice call in progress shall take precedence over all incoming paging
calls.
Name Multicast server name
Host: port Multicast server’s multicast IP address and port.
7.19 PHONE (Time/Date)
User can configure the device time settings on this page.
Table 10 - Time/Date Setting Parameters on Web
Parameters Description
Network Time Server Settings
Time Synchronized via SNTP Enable time-sync through SNTP protocol.
Time Synchronized via DHCP Enable time-sync through DHCP protocol.
Primary Time Server Set primary time server address.
Secondary Time Server
Set secondary time server address; when primary server is not
reachable, the device will try to connect to secondary time server to get
time synchronization.
Time Zone Select the time zone.
Resync Period Time of re-synchronization with time server.
12-hour Clock Set the time display in 12-hour mode.
79