User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface & Installa
- Chapter 3. Introduction to the Phone Use
- Chapter 4. IP Phone Setup
- Chapter 5. Using the Phone
- 5.1 Making Phone Calls
- 5.2 Make/Receive Second Call
- 5.3 Join/Split Two Calls (3-way Local Co
- 5.4 Call Transfer
- 5.5 Using Phonebook
- 5.6 Add/Edit/Delete Contact
- 5.7 Add/Edit/Delete Group
- 5.8 Browse and Add/Remove Contacts in Gr
- 5.9 Using Cloud Phonebook
- 5.10 Open Cloud Phonebook
- 5.11 Call Logs
- 5.12 Voice Message
- 5.13 Do-Not-Disturb
- 5.14 Auto-Answering
- 5.15 Call Forward
- Chapter 6. Phone Settings
- Chapter 7. Web Portal
- 7.1 Web Portal Authentication
- 7.2 Web Call
- 7.3 SYSTEM (Information)
- 7.4 SYSTEM (Account)
- 7.5 SYSTEM (Configurations)
- 7.6 SYSTEM (Upgrade)
- 7.7 SYSTEM (Auto Provision)
- 7.8 SYSTEM (Tools)
- 7.9 NETWORK (Basic)
- 7.10 NETWORK (Advanced)
- 7.11 NETWORK (VPN)
- 7.12 LINES (SIP)
- 7.13 LINES (Dial Peer)
- 7.14 LINES (Dial Plan)
- 7.15 LINES (Global Settings)
- 7.16 PHONE (Features)
- 7.17 PHONE (Audio)
- 7.18 PHONE (MCAST)
- 7.19 PHONE (Time/Date)
- 7.20 PHONE (Advanced)
- 7.21 PHONEBOOK (Contacts)
- 7.22 PHONEBOOK (Cloud Phonebook)
- 7.23 PHONEBOOK (Blacklist)
- 7.24 PHONEBOOK (Advanced)
- 7.25 CALL LOGS
- 7.26 FUNCTION KEY
- 7.27 FUNCTION KEY (Softkey)
- Chapter 8. Advanced Features
- Chapter 9. Troubleshooting
- Appendix I - Icon Illustration
- Appendix II - Text Input from Keypad
- Appendix III - LED Definition
Parameters Description
G.711A/U,G.722,G.723,G.729,G.726-32 ,
ILBC,AMR,AMR-WB,NONE
Fourth Codec
The forth preferential DSP codec:
G.711A/U,G.722,G.723,G.729,G.726-32 ,
ILBC,AMR,AMR-WB,NONE
Fifth Codec
The fifth preferential DSP codec:
G.711A/U,G.722,G.723,G.729,G.726-32,
ILBC,AMR,AMR-WB,NONE
Sixth Codec
The sixth preferential DSP codec:
G.711A/U,G.722,G.723,G.729,G.726-32,
ILBC,AMR,AMR-WB,NONE
Onhook Time
Configure the least reflection time of Hand down, the
default is
200ms.
Tone Standard
Set the country standard of call progress tones, including dial tone,
busy tone, ring-back tone, etc.
Default Ring Type
Set the default ring type. If the caller ID of an incoming call was not
configured with specific ring type, the default ring will be used.
Handset Volume Set the Handset volume; the value must be 1~9.
Headset Volume Set the Headset volume; the value must be 1~9.
Headset Ring Volume Set the ring volume in the headset; the value must be 1~9.
Speakerphone Volume Set the speakerphone volume; the value must be 1~9.
Speakerphone Ring Volume Set the ring volume in the speakerphone; the value must be 1~9.
Headset Volume Offset
This is to adjust the base volume of the headset. Please note when
set the volume at the maximum level it may create noise and
decrease the echo canceller.
Headset Mic Offset This is to adjust the base volume of the headset Mic.
G.729AB Payload Length Set G729 Payload Length.
G.723.1 Bit Rate 5.3kb/s or 6.3kb/s is available.
G.722 Timestamps 160/20ms or 320/20ms is available.
DTMF Payload Type Enter the DTMF payload type; the value must be 96~127.
Enable VAD
Enable Voice Activity Detection. When enabled, the device will
suppresses the audio transmission with artificial comfort noise signal
to save the bandwidth.
Enable MWI Tone
The phone will play MWI tone when a new MWI
comes.
Auto Answer By Headset When this item is checked, the device will auto-answer phone calls by
78