User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface & Installa
- Chapter 3. Introduction to the Phone Use
- Chapter 4. IP Phone Setup
- Chapter 5. Using the Phone
- 5.1 Making Phone Calls
- 5.2 Make/Receive Second Call
- 5.3 Join/Split Two Calls (3-way Local Co
- 5.4 Call Transfer
- 5.5 Using Phonebook
- 5.6 Add/Edit/Delete Contact
- 5.7 Add/Edit/Delete Group
- 5.8 Browse and Add/Remove Contacts in Gr
- 5.9 Using Cloud Phonebook
- 5.10 Open Cloud Phonebook
- 5.11 Call Logs
- 5.12 Voice Message
- 5.13 Do-Not-Disturb
- 5.14 Auto-Answering
- 5.15 Call Forward
- Chapter 6. Phone Settings
- Chapter 7. Web Portal
- 7.1 Web Portal Authentication
- 7.2 Web Call
- 7.3 SYSTEM (Information)
- 7.4 SYSTEM (Account)
- 7.5 SYSTEM (Configurations)
- 7.6 SYSTEM (Upgrade)
- 7.7 SYSTEM (Auto Provision)
- 7.8 SYSTEM (Tools)
- 7.9 NETWORK (Basic)
- 7.10 NETWORK (Advanced)
- 7.11 NETWORK (VPN)
- 7.12 LINES (SIP)
- 7.13 LINES (Dial Peer)
- 7.14 LINES (Dial Plan)
- 7.15 LINES (Global Settings)
- 7.16 PHONE (Features)
- 7.17 PHONE (Audio)
- 7.18 PHONE (MCAST)
- 7.19 PHONE (Time/Date)
- 7.20 PHONE (Advanced)
- 7.21 PHONEBOOK (Contacts)
- 7.22 PHONEBOOK (Cloud Phonebook)
- 7.23 PHONEBOOK (Blacklist)
- 7.24 PHONEBOOK (Advanced)
- 7.25 CALL LOGS
- 7.26 FUNCTION KEY
- 7.27 FUNCTION KEY (Softkey)
- Chapter 8. Advanced Features
- Chapter 9. Troubleshooting
- Appendix I - Icon Illustration
- Appendix II - Text Input from Keypad
- Appendix III - LED Definition
Parameters Description
SIP Encryption Key Set the pass phrase for SIP encryption
RTP Encryption
Enable RTP encryption such that RTP transmission will be
encrypted
RTP Encryption Key Set the pass phrase for RTP encryption
7.13 LINES (Dial Peer)
This functionality offers you more flexible dial rule; you can refer to the following contents to know how
to use this dial rule.
Parameters Description
Phone number
There are two types of matching: Full Matching or Prefix Matching. In Full
matching, the entire phone number is entered and then mapped per the Dial
Peer rules.
In prefix matching, only part of the number is entered followed by T. The
mapping with then take place whenever these digits are dialed. Prefix mode
supports a maximum of 30 digits.
Note: Two different special characters are used.
x -- Matches any single digit that is dialed.
[ ] -- Specifies a range of numbers to be matched. It may be a range, a list of ranges separated by
commas, or a list of digits.
Destination Set Destination address. This is for IP direct.
Port Set the Signal port, and the default is 5060 for SIP.
Alias
Set the Alias. This is the text to be added, replaced or deleted. It is an optional
item.
Note: There are four types of aliases.
all: xxx - xxx will replace the phone number.
add: xxx - xxx will be dialed before any phone number.
del –The characters will be deleted from the phone number.
rep: xxx - xxx will be substituted for the specified characters.
Suffix Characters to be added at the end of the phone number. It is an optional item.
Delete Length
Set the number of characters to be deleted. For example, if this is set to 3, the
phone will delete the first 3 digits of the phone number. It is an optional item.
68