User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Interface & Installa
- Chapter 3. Introduction to the Phone Use
- Chapter 4. IP Phone Setup
- Chapter 5. Using the Phone
- 5.1 Making Phone Calls
- 5.2 Make/Receive Second Call
- 5.3 Join/Split Two Calls (3-way Local Co
- 5.4 Call Transfer
- 5.5 Using Phonebook
- 5.6 Add/Edit/Delete Contact
- 5.7 Add/Edit/Delete Group
- 5.8 Browse and Add/Remove Contacts in Gr
- 5.9 Using Cloud Phonebook
- 5.10 Open Cloud Phonebook
- 5.11 Call Logs
- 5.12 Voice Message
- 5.13 Do-Not-Disturb
- 5.14 Auto-Answering
- 5.15 Call Forward
- Chapter 6. Phone Settings
- Chapter 7. Web Portal
- 7.1 Web Portal Authentication
- 7.2 Web Call
- 7.3 SYSTEM (Information)
- 7.4 SYSTEM (Account)
- 7.5 SYSTEM (Configurations)
- 7.6 SYSTEM (Upgrade)
- 7.7 SYSTEM (Auto Provision)
- 7.8 SYSTEM (Tools)
- 7.9 NETWORK (Basic)
- 7.10 NETWORK (Advanced)
- 7.11 NETWORK (VPN)
- 7.12 LINES (SIP)
- 7.13 LINES (Dial Peer)
- 7.14 LINES (Dial Plan)
- 7.15 LINES (Global Settings)
- 7.16 PHONE (Features)
- 7.17 PHONE (Audio)
- 7.18 PHONE (MCAST)
- 7.19 PHONE (Time/Date)
- 7.20 PHONE (Advanced)
- 7.21 PHONEBOOK (Contacts)
- 7.22 PHONEBOOK (Cloud Phonebook)
- 7.23 PHONEBOOK (Blacklist)
- 7.24 PHONEBOOK (Advanced)
- 7.25 CALL LOGS
- 7.26 FUNCTION KEY
- 7.27 FUNCTION KEY (Softkey)
- Chapter 8. Advanced Features
- Chapter 9. Troubleshooting
- Appendix I - Icon Illustration
- Appendix II - Text Input from Keypad
- Appendix III - LED Definition
Ending One Call
User may hang up the current call by closing the audio channel or press the [End] button. The device
will return to single call mode in holding state.
5.3 Join/Split Two Calls (3-way Local Conference)
In the dual call mode, user can join two calls into a conference call by pressing the [Conf] button. When
two calls are joined, user can split them by pressing the [Split] button.
Figure 41 - Conference Call
5.4 Call Transfer
When the user is talking with a remote party and wish to transfer the call to another remote party, there
are two ways to transfer the call, attended and unattended.
Attended Transfer
The attended call transfer is also known as the ‘polite mode’ which is to dial through the other remote
party, wait for the remote party to answer the call and then transfer the call.
This is the same procedure as making two concurrent calls. In the dual call mode, press the [XFER]
button to transfer the first party to the second one.
Unattended/Blind Transfer
Unattended transfer is also known as ‘Fire and Forget’ mode. Instead of connecting to the second party
42