User's Manual
Table Of Contents
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1.
- Chapter 1. Overview
- Chapter 2. Auto-Provisioning – For massive deployment of phones
- Chapter 3. Quality of Service (QoS) – Enhance the communication quality
- Chapter 4. Action URL and Active URI – Collaborative working environment through Computer Telephony Integration (CTI)
- Chapter 5. Active URI
- Chapter 6. Traversing NAT
16
7. Check the server URL “http:// IP:Port/” in the “Open in browser” address bar (For example, the server
URL ”http:// 192.168.1.152:8080/” is shown on the screenshot). We recommend that you can fill out the
server URL in the address bar of the web browser and then press <Enter> key to check the HTTP server
before provisioning.
2.3.4 Configure a DHCP server
Before configuring the DHCP Server, please make sure that:
There is no DHCP server in your local system. Or it will cause some unknown consequences on deploy
procedure.
If you have a dhcpsrv2.3 application installed on your computer, open it now, or otherwise, download and
install it.
To configure a DHCP server:
1. Open the dhcpsrv2.3 folder
2. Open the application “dhcpwiz.exe” to configure the DHCP Server.