User's Manual
Table Of Contents
- Preface
- 1 Introduction of VGW-X20FS SERIES
- 2 Basic Operations
- 3 Configurations on Web Interface
4-/8-/16-/24-/32-Port SIP Internet Telephony Gateway
58
3.11.2 Route any calls from any IP to specified port group
Create port group
Before we can route calls to a port group, create the port group first as shown below. On the Call &
Routing
Port Group, click Add to create a new port group.
Port 0 to port 2 are assigned to port group 7.
Route any calls to the port group
On the Call & Routing
IP-Tel Routing interface, click Add to create a new routing rule.
As shown above, if the routing rule is matched, calls will be routed to port group 7.