User's Manual

4-/8-/16-/24-/32-Port SIP Internet Telephony Gateway
18
*# Dial *# to place a call on hold
*47* Dial *47* to establish a call through IP address
*51# Dial *51# to enable ‘call waiting’ feature
*50# Dial *50# to disable ‘call waiting’ feature
*87* Dial *87* to blind transfer a call
*72* Dial *72* to enable ‘unconditional call forwarding’ feature
*73# Dial *73# to disable ‘unconditional call forward’ feature
*90* Dial *90* to enable ‘busy call forwarding’ feature
*91# Dial *91# to disable ‘busy call forwarding’ feature
*92* Dial *92* to enable ‘no answer call forwarding’ feature
*93# Dial *93# to disable ‘no answer call forwarding’ feature
*78# Dial *78# to enable DND
*79# Dial *79# to disable DND
*200# Dial *200# to access voice mail
Flash/Hook
Used to switch between incoming calls. If the phone is
not in session,
flash/hook will switch a new channel for a new call.
2.8 Sending and Receiving Fax
The VGW-X20FS SERIES gateway supports four fax modes:
T.38 (FoIP)
Pass-through
Modem
Adaptive
2.8.1 T. 38 and Pass-through
T.38 is the preferred fax mode because it is more reliable and works well in most network conditions.
If the service provider supports T.38, please use this method by selecting T.38 as fax mode (default).
If the service provider does not support T.38, pass-through mode may be used. If you have problems
with sending or receiving Fax, toggle the Fax Tone Detection Mode setting.