User's Manual

16
(7) The relation of the video of optical transmitter and optical receiver is
one-to-one, which means V1~V4 of optical transmitter is one-to-one to V1~V4
of optical transmitter.
3.3 Order for installation
(1) Connect the interface of optical transmitter with camera or speed dome. Then
connect the optical ber and the power supply.
(2) Connect the interface of optical receiver with video interface, monitor, video
matrix and displayer. Then connect the optical ber and the power supply.
(3) Insert the power supply according to the conguration of device, correctly
accessing peripheral attachment. Check optical ber, data cable, video cable,
etc. on the basis of wiring diagram (accompanied with each set of optical
transceiver) of optical transceiver.
(4) After all the connection and passing inspection, power on to see if device runs
normally.
(5) Please install the lightning protection facilities and make sure the ground
connection is good when installing this device in the open air.
3.4 Stand-alone Installation
To install a VF-402-T/VF-402-R stand-alone on a desktop or shelf, simply complete
the following steps:
(1) Turn off the power of the analog camera/monitor to which the VF-402-T/
VF-402-R will be attached.
(2) VF-402-T (Transmitter): Connect coaxial cable from analog camera to video
BNC port of the VF-402-T.
(3) Attach FC single mode ber cable from the VF-402-T to VF-402-R in the
remote side.
Note
After the VF-402-KIT is powered on, wait for at least 15 seconds
before connecting the connector to the optical fiber port or else the
connector may be damaged or you may get an electric shock.
(4) VF-402-R (Receiver): Connect coaxial cable from monitor/DVR to Video BNC
port of the VF-402-R.