VF-10x-KIT User Manual

3.3 Chassis Installation and Rack Mounting

To install the Video over ber Converter in a 10-inch or

19-inch Converter Chassis with standard rack, follow the

instructions described below.

Step 1: Place your Converter Chassis on a hard at surface,

with the front panel positioned toward your front side.

Step 2: Carefully slide in the module until it is fully and rmly

tted into the slot of the Converter Chassis.

Figure 3-2: Insert a video over ber converter into an available slot

Step 3: Attach a rack-mount bracket to each side of the

Converter Chassis with supplied screws attached to

the package.

Step 4: After the brackets are attached to the Converter

Chassis, use suitable screws to securely attach the

brackets to the rack.

Step 5: Proceed with steps 4 and 5 of Section 3.2 Stand-

alone Installation to connect the video and ber

cabling and supply power to your Converter Chassis.