VF-10x-KIT User Manual

3 Installing The Converter

This section describes how to install your VF-10x Media

Converter and make connections to the converter. Please read

the following sections and perform the procedures in the order

being presented. The hardware installation of PLANET VF-10x

Media Converter does not need software conguration. To

install your VF-10x on a desktop or shelf, simply complete the

following steps.

3.1 Limitation

The converter does not require any software conguration.

Users can immediately use any feature of this product simply by

attaching the cables and turning the power on. However, there

are some key limitations on the video over ber converter as

shown below:

n The device is used for Point-to-Point connection only (trans-

mitter to receiver) and allows video and data to work on the

same optical ber patch cord.

n The BNC connector supports 75 ohm cable. The maximum

distance will change with the quality of coaxial cables.

3.2 Stand-alone Installation

To install a VF-10x-T/VF-10x-R stand-alone on a desktop or

shelf, simply complete the following steps:

Step 1: Turn off the power of the analog camera/monitor to

which the VF-10x-T/VF-10x-R will be attached.

Step 2: VF-10x-T (Transmitter): Connect coaxial cable from

analog camera to video BNC port of the VF-10x-T.