(V2) User Manual
16
Building a IP surveillance system
Refer to the following procedure to set up many pairs of
VC-232G to IP surveillance system.
1. Set the VC-232G to be CO and CPE mode from the DIP
switch on the rear panel.
2. Power on the VC-232G by connecting its power source.
3. Power LED will illuminate.
4. Connect Coaxial cable from VDSL port of two VC-232G units.
5. VDSL LED will blink to illuminate.
6. Connect Ethernet port to IP cameras via regular Cat. 5, 5e or
6 cable.
7. Install the NVR and Monitor and connect to one Ethernet
switch
8. You can get data transmissions from all IP cameras.