User's Manual

Appendix: Wall-mount and Chassis Installation

This part describes how to install your VDSL2 Bridge and make

connections to it.

Please read the following topics and perform the procedures in

the order being presented.

 Wall-mount Installation

Step 1: Please nd the wall that can mount the VDSL2 Bridge.

Step 2: Screw two screws on the wall.

Step 3: Hang the VDSL2 Bridge on the screws from the wall.

Step 4: Refer to chapter 3.3 Power Information for power supply

to the VDSL2 Bridge.

Note

Before mounting the device to the wall, please

check the location of the electrical outlet and the

length of the Ethernet cable.

VC-231G/VC-231GF Switch Bottom Side

Ø7mm

Ø2mm