Power over Coaxial Extender VC-203PT and VC-203PR User's Manual
Trademarks Copyright © PLANET Technology Corp. 2013. Contents are subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. other trademarks belong to their respective owners.
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CE Mark Warning This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
Table of Contents 1. INTRODUCTION......................................................................... 5 1.1 Package Contents................................................................ 5 1.2 Product Features.................................................................. 6 1.3 Product Specifications.......................................................... 7 1.4 Physical Dimensions............................................................10 2. INSTALLATION......................................
1. INTRODUCTION Thank you for purchasing PLANET Industrial Power over Coaxial Extender, VC-203PT and VC-203PR. The descriptions of the two models are as follows: VC-203PT PoE over Coaxial Extender - Transmitter (1-Port 10/100TX 802.3at PoE PD + 1-Port BNC PoE ) VC-203PR PoE over Coaxial Extender - Receiver (1-Port 10/100TX 802.3at PoE PSE + 12/24V DC Splitter) “Industrial Power over Coaxial Extender” mentioned in this Manual represents the above two models. 1.
1.2 Product Features Physical Port Ports Model Name Copper BNC VC-203PT 1 x 10/100Base-TX (PoE IN) Power/Data Transmitter VC-203PR 1 x 10/100Base-TX (PoE OUT) Power/Data Receiver Power over Ethernet ll Eliminates Power cabling with PoE over Coaxial ll Ethernet over coaxial up to 1km with 5C2V/RG6 75Ω cable ll Complies with IEEE 802.3af / IEEE 802.3at Power over Ethernet on RJ-45 ports ll Supports PoE Power up to 30.
1.3 Product Specifications Model VC-203PT VC-203PR Hardware Specifications Copper 10/100Base-TX RJ-45 Auto-negotiation/ Auto-MDI/MDI-X 802.3at/af PoE Input 10/100Base-TX RJ-45 Auto-negotiation/ Auto-MDI/MDI-X 802.
Installation Wall mount or DIN rail with optional kit Dimensions (W x D x H) 94 x 70.3x 39.2 mm Weight 288g 302g Power Requirements RJ-45 PoE Input: 802.
Regulation Compliance FCC Part 15 Class A, CE Environment Temperature Operating: -40~75 degrees C Storage: -40~75 degrees C Humidity Operating: 5~95% (Non-condensing) Storage: 5~95% (Non-condensing) Cable Coaxial RG-6/U cable (Recommended) max. 500 m with PoE+ (1,640 ft.) max. 700 m with PoE (2,297 ft.) max. 1200 m without PoE (3,937 ft.) * The actual data rate will vary on the quality of the copper wire and environment factors.
/100Base-TX PoE IN VC-203PT PoE over Coaxial Extender Coaxial LNK CO CPE PoE IN PWR LNK/ACT 100 LAN Transmitter 1 2 ON OFF Asymm Mode Band Plan CO Symm CPE ON 10 Transmitter PoE over Coaxial Extender 52~56V DC IN 1.4 Physical Dimensions VC-203PT dimensions (W x D x H): 94 x 70.3 x 39.
PoE 12V Out V+ DC Out PoE IN LNK CO CPE DC Out 24V 10/100Base-TX PoE Out VC-203PR PoE over Coaxial Extender Coaxial Receiver LAN 100 LNK/ACT PWR PoE Out PoE over Coaxial Extender Asymm OFF 1 2 ON ON CPE Mode Band Plan CO Symm Receiver 52~56V DC IN VC-203PR dimensions (W x D x H): 94 x 70.3 x 39.
2. INSTALLATION This section describes the functionalities of the Industrial Power over Coaxial Extender’s components and guides you to how to install it on the desktop. Basic knowledge of networking is expected. Please read this chapter completely before continuing. 2.1 Product Description Power over Coaxial Based on IEEE 802.
2.1.1 Power over Coaxial Extender Front Panel Figure 2-1 and Figure 2-2 show the front panels of the VC-203PT and VC-203PR Industrial Power over Coaxial Extenders.
Coaxial / VDSL2 Interfaces LED Color Function Light: indicates that the coaxial link is established. LNK Green Fast Blink: indicates that the coaxial link is at training status (about 10 seconds). Slow Blink: indicates that the coaxial link is at idle status. CO Green Light: indicates the coaxial Bridge is running at CO mode. CPE Green Light: indicates the coaxial Bridge is running at CPE mode.
2.1.3 Power over Coaxial Extender Rear Panel Figure 2-3 and Figure 2-4 show the rear panels of the VC-203PT and VC-203PR Industrial Power over Coaxial Extenders.
2.2 Applications of VC-203PT and VC-203PR Type 1 – VC-203PT with 52~56V power adapter and VC-203PR with PoE power output 110-240V AC AC-to-DC Adapter 60W/52~56V DC IN VC-203PR PoE Transmitter Receiver RJ-45 VC-203PT RJ-45 PoE over Coaxial Extender PoE over Coaxial Extender Ethernet Switch 802.3af/802.
CPE CO VC-203PT VC-203PR Power Input Power adapter with 52~56V DC in BNC with DC power over coaxial input Power Output BNC with DC power over coaxial output DC Terminal block with 12V or 24V DC output Caution 1. Please ensure the VC-203PR output voltage is correct for remote device. 2. Please plug off the PoE Coaxial cable from VC-203PR before switching off the Power Voltage DIP during operation. Wait for 3 seconds until the “PoE IN” LED is completely OFF. Otherwise, it might damage your devices.
Type 4 – VC-203PT with PoE power input and VC-203PR with DC power output VC-203PR Receiver / VDSL2 CO PoE RJ-45 Transmitter Receiver 802.3af / 802.3at PoE Switch VC-203PT PoE over Coaxial Extender PoE over Coaxial Extender RJ-45 12V/24V DC Non-PoE IP Camera Power over Coaxial Transmitter / VDSL2 CPE CPE CO VC-203PT VC-203PR Power Input RJ-45 with 802.
Power Input CPE CO VC-202A / IVC-2002 VC-203PR Power adapter with 5V DC in does not support power Power Output output Power adapter with 52~56V DC in ● RJ-45 with 802.3at/af PoE output ● DC Terminal block with 12V or 24V DC output As the VC-203PT is power over coaxial, please confirm that other Non-PoE equipment is not connected with the coaxial cable. When you connect the coaxial cable with coax-LAN converter, CCTV camera, etc, it might cause other equipment to damage.
3. TROUBLESHOOTING This chapter contains information to help you solve issues. If the Industrial Power over Coaxial Extender is not functioning properly, make sure the Industrial Power over Coaxial Extender was set up according to instructions in this manual. VDSL LNK LED does not light after wire is connected to the VDSL port. CHECKPOINT: 1. Verify the length of the wire connected between VC-203PT and VC-203PR. It should not be more than 2.4km. 2.
Why can’t power be on when my PoE PD device is connected to VC-203PR ? CHECKPOINT: 1. Please check the cable type of the connection from VC-203PR to the other end. The cable should be an 8-wire UTP, Category 5 or above, and EIA568 cable within 100 meters. A cable with only 4-wire, short loop or over 100 meters will affect the power supply. 2. Please check and assure the device is fully complied with IEEE 802.3af / IEEE 802.3at standard.
APPENDIX A: NETWORKING CONNECTION A.1 Switch’s RJ-45 Pin Assignments 10/100Mbps, 10/100Base-TX RJ-45 Connector pin assignment Contact MDI-X MDI Media Dependant Interface Media Dependant Interface -Cross 1 Tx + (transmit) Rx + (receive) 2 Tx - (transmit) Rx - (receive) 3 Rx + (receive) Tx + (transmit) 4, 5 6 7, 8 Not used Rx - (receive) Tx - (transmit) Not used A.
Straight Cable 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 Crossover Cable 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 SIDE 1 SIDE 2 SIDE 1 SIDE 2 SIDE 1 SIDE 2 1 = White/Orange 2 = Orange 3 = White/Green 4 = Blue 5 = White/Blue 6 = Green 7 = White/Brown 8 = Brown 1 = White/Orange 2 = Orange 3 = White/Green 4 = Blue 5 = White/Blue 6 = Green 7 = White/Brown 8 = Brown SIDE 1 SIDE 2 1 = White/Orange 2 = Orange 3 = White/Green 4 = Blue 5 = White/Blue 6 = Green 7 = White/Brown 8 = Brown 1 = White/Green 2 = Green 3 = Whit
EC Declaration of Conformity For the following equipment: *Type of Product: PoE over Coaxial Extender - Transmitter PoE over Coaxial Extender - Receiver with 12/24V DC Splitter *Model Number: VC-203PT & VC-203PR * Produced by: Manufacturer’s Name : Manufacturer’s Address: Planet Technology Corp. 10F., No.96, Minquan Rd., Xindian Dist. New Taipei City 231, Taiwan (R.O.C.).
