16-port + 2 Gigabit-slots VDSL Stackable Switch User's Manual VC-1602

- 22 -
Configuration
Port attributes can be setup in this page.
Setup Port Attributes
- VDSL port
1. Click the “Name” column of the port. Enter a name for identification, like ‘Richard’;
and press Enter.
2. Leave the “Admin” column ‘Enable’ value to make the port to be in operation
or ’Disable’ to pause it.
3. Select Profile. 5 profiles available, ANSI, ETSI, VE-5, VE-10 and VE-15. Please
check chapter 2.1 for the data rate of each speed and their maximum connection
distance.
4. Select the predefined “Bandwidth Ctrl” scale to limit the available bandwidth to 10%,
20%, to 100%.
5. Click Apply button to apply settings.
- Gigabit module port
1. Click the “Name” column of the port. Enter a name for identification, like ‘Richard’;
and press Enter.
2. Leave the “Admin” column ‘Enable’ value to make the port to be in operation
or ’Disable’ to pause it.
3. Select “Speed/Duplex” mode. 5 modes are supported, 10Half, 10Full, 100Half,
100Full and Auto for auto-negotiation. Please note the fiber modules support only
Auto for 1000Mbps, full duplex operation.
4. Select ‘Enable’ on the “Flow Ctrl” field to enable 802.3x full duplex flow control or
back pressure half duplex flow control.
5. Click Apply button to apply settings.
ëNote
Also accomplished by simply mouse right-click the port on the ‘Pane
l
Display’ then select ‘Configuration’, the configuration screen pops up.