User Manual

User’s Manual of UPOE-800G/UPOE-1600G/UPOE-2400G
47
4.5.1 PoE Configuration
This section provides PoE (Power over Ethernet) Configuration and PoE output status of Ultra PoE Managed Injector Hub
as screen in Figure 4-5-2 appears. Table 4-5-2 describes the PoE Configuration object of Ultra PoE Managed Injector Hub.
Figure 4-5-2: PoE Configuration Web Page Screen
Object
Description
• System PoE Admin Mode
Allows user to disable / enable PoE function.
• Power Supply
Displays PoE power supply status.
• Power Limit Mode
Allows user to configure power limit mode, which can be chosen.
Consumption: Based on the real device power consumption where PoE power is
delivered as system default setting is in this mode.
Allocation: Users allow to assign how much PoE power to each port and the system
will reserve PoE power to PD.
• Over Temperature
Protection
Prevent system from being too hot that may cause damage. When PoE unit
temperature rises over the temperature threshold value, PoE power budget will be
reduced.
• PoE Temperature Unit 1
Displays the current operating temperature of PoE chip unit 1.
• PoE Temperature Unit 2
Displays the current operating temperature of PoE chip unit 2.
• PoE Temperature Unit 3
Displays the current operating temperature of PoE chip unit 3. (UPOE-1600G only)
• PoE Temperature Unit 4
Displays the current operating temperature of PoE chip unit 4. (UPOE-1600G only)
• PoE Temperature Unit 5
Displays the current operating temperature of PoE chip unit 5. (UPOE-2400G only)
• PoE Temperature Unit 6
Displays the current operating temperature of PoE chip unit 6. (UPOE-2400G only)