User Manual

User’s Manual of UPOE-800G/UPOE-1600G/UPOE-2400G
23
2.2.3 Network Application Installation
The Ultra PoE Managed Injector Hub is not an equipment with data switching function between data ports. To inject PoE
power and transmit data packets to PDs, the Ultra PoE Managed Injector Hub is usually linked to an Ethernet switch.
Typically, the Ultra PoE Injector is installed between regular Ethernet switch and PDs, and mostly it is located close to the
Ethernet switch side.
To install an Ultra PoE Managed Injector Hub on a network environment, simply complete the following steps:
Step 1: Power on the Ultra PoE Managed Injector Hub and connect the RJ45 cable from the “Data” port to the Ethernet
switch port.
Step 2: Connect the RJ45 cable from the “Data + Power” ports to the PDs, such as VoIP phone and IP camera.
Step 3: Check the link status on both PD and Ethernet switch. Once the Injector starts to deliver 52V/54V power over RJ45
cables to PDs, the PoE-in-Use LED of the Ultra PoE Managed Injector Hub will light up.
Figure 2-2-4: Network application installation
The Ultra PoE Managed Injector Hub supports data passive mode, that is, even the Ultra PoE Managed Injector Hub is
manually powered off. The data between “DATA” port and “DATA & PWR” port can still be transmitted without data loss.