User Manual

User’s Manual of UPOE-800G/UPOE-1600G/UPOE-2400G
21
Figure 2-2-1: Desktop Installation of the Ultra PoE Managed Injector Hub
When choosing a location, please keep in mind the environmental restrictions d
iscussed in Chapter
1, Section 5, under Specifications.
Step 4: Connect your Ultra PoE Managed Injector Hub to network 60W/802.3at/802.3af powered devices (PD) and Switch.
A. Connect one end of a standard network cable to the upper stack 10/100/1000 RJ45 ports on the front of the Ultra
PoE Managed Injector Hub.
B. Connect the other end of the cable to the 60W/802.3at/802.3af powered devices (PD) such as IP phone, wireless
access point, IP camera, splitter, or switch etc.
C. Connect one end of a standard network cable to the relative lower stack 10/100/1000 RJ45 port on the front of
the Ultra PoE Managed Injector Hub.
D. Connect the other end of the cable to the port of Switch.
Connecting to the Ultra PoE Managed Injector Hub requires UTP Category 5e / 6 network cabling
with RJ45 tips. For more information, please see the Cabling Specification in Appendix A.
Step 5: Supplying Power to the Ultra PoE Managed Injector Hub.
A. Connect one end of the power cable to the Ultra PoE Managed Injector Hub.
B. Connect the power plug of the power cable to a standard wall outlet.
When the Ultra PoE Managed Injector Hub receives power, the Power LED should remain solid Green.
2.2.2 Rack Mounting
To install the Ultra PoE Managed Injector Hub in a 19-inch standard rack, follow the instructions described below.
Step 1: Place your Ultra PoE Managed Injector Hub on a hard flat surface, with the front panel positioned towards your
front side.
Step 2: Attach a rack-mount bracket to each side of the Ultra PoE Managed Injector Hub with supplied screws attached to
the package. Figure 2-2-2 shows how to attach brackets to one side of the Ultra PoE Managed Injector Hub.