Manual
Table Of Contents
- 1. INTRODUTION
- 2. INSTALLATION
- 3. SWITCH MANAGEMENT
- 4. WEB CONFIGURATION
- 4.1 Main WEB PAGE
- 4.2 System
- 4.3 Simple Network Management Protocol
- 4.4 Port Management
- 4.5 Link Aggregation
- 4.6 VLAN
- 4.7 Rapid Spanning Tree Protocol
- 4.8 Quality of Service
- 4.9 Multicast
- 4.10 IEEE 802.1X Network Access Control
- 4.10.1 Understanding IEEE 802.1X Port-Based Authentication
- 4.10.2 802.1X System Configuration
- 4.10.3 802.1X and MAC-Based Authentication Port Configuration
- 4.10.4 802.1X Port Status
- 4.10.5 802.1X and MAC-Based Authentication Statistics
- 4.10.6 Windows Platform RADIUS Server Configuration
- 4.10.7 802.1X Client Configuration
- 4.11 Access Control Lists
- 4.12 Address Table
- 4.13 Port Security (To be Continued)
- 4.14 LLDP
- 4.15 Network Diagnastics
- 4.16 Stacking – SGSW-24040 / SGSW-24040R
- 4.17 Power over Ethernet (SGSW-24040P / SGSW-24040P4)
- 5. COMMAND LINE INTERFACE
- 6. Command Line Mode
- 6.1 System Command
- 6.2 Port Management Command
- 6.3 Link Aggregation Command
- 6.4 VLAN Configuration Command
- 6.5 Spanning Tree Protocol Command
- 6.6 Multicast Configuration Command
- 6.7 Quality of Service Command
- 6.8 802.1x Port Access Control Command
- 6.9 Access Control List Command
- 6.10 MAC Address Table Command
- 6.11 LLDP Command
- 6.12 Stack Management Command
- 6.13 Power over Ethernet Command
- 7. SWITCH OPERATION
- 8. POWER OVER ETHERNET OVERVIEW
- 9. TROUBLE SHOOTING
- APPENDEX A
- APPENDEX B : GLOSSARY
User’s Manual of WGSW-24040 Series
SGSW-24040/24240 Series
273
Syntax:
QoS Rate Limiter [<port_list>] [enable|disable] [<bit_rate>]
Parameters:
<port_list>: Port list or 'all', default: All ports
enable : Enable rate limiter
disable : Disable rate limiter
(default: Show rate limiter mode)
<bit_rate> : Rate in 1000 bits per second (500-1000000 kbps)
Default Setting:
Disabled, 500kbps
Example:
Set 1000kbps rate limiter for port17~24
SWITCH/>qos rate limiter 17-24 enable 1000
QoS Shaper
Description:
Set or show the port shaper.
Syntax:
QoS Shaper [<port_list>] [enable|disable] [<bit_rate>]
Parameters:
<port_list>: Port list or 'all', default: All ports
enable : Enable shaper
disable : Disable shaper
(default: Show shaper mode)
<bit_rate> : Rate in 1000 bits per second (500-1000000 kbps)
Default Setting:
Disabled, 500kbps
Example:
Set 1000kbps shaper for port 9~16