User's Manual

80-3
8. Set the power priority on specified ports
80.3 Typical Application of PoE
Requirements of Network Deployment
Set the max output power of DCRS-5960-28T-POE to 370W, assuming that the default max power can
satisfy the requirements.
Ethernet interface 1/0/2 is connected to an IP phone.
Ethernet interface 1/0/4 is connected to a wireless AP.
Ethernet interface 1/0/6 is connected to a Bluetooth AP.
Ethernet interface 1/0/8 is connected to a network camera.
The IP phone connected to Ethernet interface has the highest-level power supply priority: critical, which
requires the power supply to the newly connected PD being cut off if it causes PSE power-overload (i.e.
adopting the priority policy of PD power management).
Power of subordinate AP devices connected to Ethernet interface 1/0/6 should not exceeds 9000mW.
Topology of Network
Command
Explanation
Port Mode
power inline priority {critical | high | low}
Set the power priority on specified ports.