User's Manual

49-24
2
．
Destination control
We want to confine that the users of the segment whose address is fe80::203:fff:fe01:228a/64 can not join the
ff1e::1/64 group, so we can configure as follows:
First, enable MLD Snooping in the VLAN where it locates (in this example, it is VLAN2).
Switch(config)#ipv6 mld snooping
Switch(config)#ipv6 mld snooping vlan 2
Then configure relative destination control access list and configure specified IPv6 address to use this access
list.
Switch(config)#ipv6 access-list 9000 deny any ff1e::1/64
Switch(config)#ipv6 access-list 9000 permit any any
Switch(config)#multicast destination-control
Switch(config)#ipv6 multicast destination-control fe80::203:fff:fe01:228a/64 access-group 9000
Thus, the users of this segment can only join groups other than 2ff1e::1/64.
3
．
Multicast policy
Server 2008::1 is sending important multicast data in group ff1e::1, we can configure on its access switch as
follows:
Switch(config)#ipv6 multicast policy 2008::1/128 ff1e::1/128 cos 4
Thus this multicast flow will have a priority of 4, when it passes the TRUNK port of this switch to another
switch (generally speaking, it is a relatively high priority, the data with higher priority might be protocol data, if
a higher priority is set, when there is too much multicast data, the switch protocol might operate abnormally).
49.5.4 IPv6 DCSCM Troubleshooting
IPv6 DCSCM module acts like ACL, so most problems are caused by improper configuration. Please read the
instructions above carefully.
49.6 MLD
49.6.1 Introduction to MLD
MLD (Multicast Listener Discovery) is the multicast group member (receiver) discovery protocol serving IPv6
multicast. It is similar to IGMP Protocol in IPv4 multicast application. Correspondingly, MLD Protocol version1
is similar to IGMP Protocol version2, and MLD Protocol version2 is similar to IGMP Protocol version3. Current
firmware supports MLDv1/ MLDv2.
The IPv6 multicast hosts can join or leave from multicast group at any location, any time, regardless of the