User's Manual

49-10
ipv6 pim rp-candiate
{vlan<vlan-id>|
loopback<index>|<ifname>}
[<group range>] [<priority>]
no ipv6 pim rp-candiate
This command is the global candidate RP
configuration command, which is used to
configure the information of PIM-SM candidate
RP so that it can compete for RP router with
other candidate RP. The no
operation is to
cancel the configuration of RP.
3) Configure static RP
Command
Explanation
Global Configuration Mode
ipv6 pim rp-address <rp-address>
[<group-range>]
no ipv6 pim rp-address
<rp-address> {all|<group-range>}
To configure the address of the candidate RP.
The no form of this command will remove the
configuration for the candidate RP.
4) Configure the cache time of kernel multicast route
Command
Explanation
Global Configuration Mode
ipv6 multicast unresolved-cache
aging-time <value>
no ipv6 multicast unresolved-cache
aging-time
Configure the cache time of kernel multicast
route, the no
command restores the default
value.
4. Disable PIM-SM protocol
Command
Explanation
Interface Configuration Mode
no ipv6 pim sparse-mode
To disable the PIM-SM6 protocol.
Global Configuration Mode
no ipv6 pim sparse-mode
To disable PIM-DM globally.
49.2.3 PIM-SM6 Typical Application
As shown in the following figure, add the Ethernet interfaces of SwitchA, SwitchB, SwitchC and SwitchD to
corresponding VLAN, and start PIM-SM Protocol on each VLAN interface.