User's Manual

Table Of Contents
49-9
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of
PIM-SM6 protocol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
5) Configure the interface as the management boundary of the PIM-SM6 protocol
Command
Explanation
Interface Configuration Mode
ipv6 pim scope-border
<500-599>|<acl_name>
no ipv6 pim scope-border
To configure PIM-SM6 management boundary
for the interface and apply ACL for the
management bounda
ry. With default settings,
ffx0::/13 is considered as the scope of the
management group. If ACL is configured, then
the scope specified by ACL permit command is
the scope of the management group. acl_name
should be standard IPv6 ACL name. The no
form of th
is command will remove the
configuration.
2
Configure global PIM-SM6 parameter
1) Configure the switch as a candidate BSR
Command
Explanation
Global Configuration Mode
ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[hash-mask-length]
[priority]
no Ipv6 pim bsr-candiate {vlan
<vlan_id>|<ifname> | tunnel
<1-50>}[hash-mask-length]
[priority]
This command is the global candidate BSR
configuration command, which is used to
configure the information of PIM-SM candidate
BSR so that it can compete for BSR router with
other candidate BSR. The no operation is to
cancel the configuration of BSR.
2) Configure the switch as a candidate RP
Command
Explanation
Global Configuration Mode