User's Manual

48-17
48.4.3.1 Prerequisites of MSDP Configuration
Before the MSDP basic functions can be configured, the following tasks should be done:
 At least one single cast routing protocol should be configured, in order to connect the network inside the
domain and outside
 Configure PIM-SM in order to implement multicast inside the domain
When configuring MSDP basic function, the following information should be ready:
 The IP address of MSDP entities
 Filter policy table
Pay attention: MSDP can not use with Any-cast RP at same time, but configure Any-cast RP of based MSDP
protocol.
48.4.3.2 Enabling MSDP
MSDP should be enabled before various MSDP functions can be configured.
1. Enable the MSDP function
2. Configure MSDP
1. Enabling MSDP
Commands
Explanation
Global Configuration Mode
router msdp
no router msdp
To enable MSDP. The no form of this
command will disable MSDP globally.
2. Configuration of MSDP parameters
Commands
Explanation
MSDP Configuration Mode
connect-source <interface-type>
<interface-number>
no connect-source
To configure the Connect-Source interface for
MSDP Peer. The no form of this command
will remove the configured Connect-Source
interface.
default-rpf-peer <peer-address> [ rp-policy
<acl-list-number> | <word> ]
no default-rpf-peer
To configure static RPF Peer. The no form of
this command will remove the configured
RPF Peer.
originating-rp <interface-type>
<interface-number>
no originating-rp
To configure Originator-RP. The no form of
this command will remove the configured
Originator-RP.
ttl-threshold <ttl>
no ttl-threshold
To configure the TTL value. The no form of
this command will remove the configured TTL
value.