User's Manual

Table Of Contents
12-5
7. Set the timeout mode of the current port in LACP protocol
Command
Explanation
Port mode
lacp timeout {short | long}
no lacp timeout
Set the timeout mode in LACP protocol. The
no command restores the default value.
12.4 Port Channel Examples
Scenario 1: Configuring Port Channel in LACP.
Figure 12-2 Configuring Port Channel in LACP
The switches in the description below are all switch and as shown in the figure, ports 1, 2, 3, 4 of S1 are
access ports and add them to group1 with active mode. Ports 6, 8, 9, 10 of S2 are access ports and add them
to group2 with passive mode. All the ports should be connected with cables.
S1
S2