SGS-6341-Series User Manual

7-8
1. Enter the Ethernet port configuration mode
Command Explanation
Global Mode
interface ethernet <interface-list>
Enters the network port configuration mode.
2. Configure the properties for the Ethernet ports
Command Explanation
Port mode
media-type {copper |
copper-preferred-auto | fiber |
sfp-preferred-auto}
Sets the combo port mode (combo ports
only).
shutdown
no shutdown
Enables/Disables specified ports.
description <string>
no description
Specifies or cancels the name of specified
ports.
mdi {auto | across | normal}
no mdi
Sets the cable type for the specified port; this
command is not supported by combo port
and fiber port of switch.
speed-duplex {auto [10 [100 [1000]]
[auto | full | half |]] | force10-half |
force10-full | force100-half |
force100-full | force100-fx
[module-type {auto-detected |
no-phy-integrated | phy-integrated}] |
{{force1g-half | force1g-full}
[nonegotiate [master | slave]]}|
force10g-full}
no speed-duplex
Sets
port speed and duplex mode of
100/1000BASE-TX or 1000BASE-X ports.
The no format of this command restores the
default setting, i.e., negotiates speed and
duplex mode automatically.
negotiation {on|off}
Enables/Disables the auto-negotiation
function of 1000BASE-X ports.
bandwidth control <bandwidth> [both |
receive | transmit]
no bandwidth control
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports.
flow control
no flow control
Enables/Disables traffic control function for
specified ports.
loopback
no loopback
Enables/Disables loopback test function for
specified ports.
User’s Manual of SGS-6341 series