SGS-6341-Series User Manual

6-6
6.4 Cluster Administration Troubleshooting
When encountering problems in applying the cluster admin, please check the following
possible causes:
 The command switch should be correctly configured and the automatically added
function (cluster auto-add) is enabled. The ports are connected to the command switch
and member switch belongs to the cluster vlan.
 After cluster commander is enabled in VLAN1 of the command switch, please don’t
enable a routing protocol (RIP, OSPF, BGP) in this VLAN in order to prevent the routing
protocol from broadcasting the private cluster addresses in this VLAN to other switches
and cause routing loops.
 Whether the connection between the command switch and the member switch is correct.
We can use the debug cluster packets to check if the command and the member
switches can receive and process related cluster admin packets correctly.
User’s Manual of SGS-6341 series