SGS-6341-Series User Manual

6-5
snmp-server enable
Enable snmp server function in
commander switch and member
switch.
Note: Ensure the SNMP server
function is enabled in member switch
when commander switch visiting
member switch by sn. The
commander switch visit member
switch via configure character string
<commander-community>@sw<me
mber id>.
6.3 Examples of Cluster Administration
Scenario:
Among the four switches -- SW1, SW2, SW3 and SW4 -- SW1 is the command switch and the
other switches are member switch. The SW2 and SW4 are directly connected with the
command switch while SW3 connects to the command switch through SW2.
E1 E2 E1 E2 E1 E1
SW1
Figure 6-1: E
xamples of Cl
uster
SW2
SW3 SW4
Configuration Proce
dure
1. Configure the command switch
Configuration of SW1:
Switch(config)#cluster run
Switch(config)#cluster ip-pool 10.2.3.4
Switch(config)#cluster commander 5526
Switch(config)#cluster auto-add
2. Configure the member switch
Configuration of SW2-SW4
Switch(config)#cluster run
User’s Manual of SGS-6341 series