SGS-6341-Series User Manual

4-2
banner motd <LINE>
no banner motd
Configure the information displayed when the
login authentication of a Telnet or console user is
successful.
4.2 Telnet Management
4.2.1 Telnet
4.2.1.1 Introduction to Telnet
Telnet is a simple remote terminal protocol for remote login. Using Telnet, the user can login to
a remote host with its IP address of hostname from his own workstation. Telnet can send the
user’s keystrokes to the remote host and send the remote host output to the user’s screen
through TCP connection. This is a transparent service, as to the user, the keyboard and
monitor seems to be connected to the remote host directly.
Telnet employs the Client-Server mode; the local system is the Telnet client and the remote
host is the Telnet server. Switch can be either the Telnet Server or the Telnet client. When
switch is used as the Telnet server, the user can use the Telnet client program included in
Windows or other operating systems to login to switch, as described earlier in the In-band
Management section. As a Telnet server, switch allows up to 5 Telnet client TCP connections.
And as Telnet client, using telnet command under Admin Mode allows the user to login to the
other remote hosts. Switch can only establish TCP connection to one remote host. If a
connection to another remote host is desired, the current TCP connection must be dropped.
4.2.1.2 Telnet Configuration Task List
2. Configure Telnet Server
2. Telnet to a remote host from the switch.
1. Configure Telnet Server
Command Explanation
Global Mode
telnet-server enable
no telnet-server enable
Enable the Telnet server function in the
switch: the no command disables the
Telnet function.
username <user-name> [privilege
<privilege>] [password [0 | 7] <password>]
no username <username>
Configure user name and password of
the Telnet. The no form command
deletes the Telnet user authorization.
User’s Manual of SGS-6341 series