SGS-6341-Series User Manual

User’s Manual of SGS-6341 series
Switch Rear Panel
The rear panel of the Managed Switch indicates an AC inlet power socket, which accepts input power from 100 to
240V AC, 50-60Hz. Figure 2-5 shows the rear panel of this Managed Switch.
SGS-6341-24T4X & SGS-6341-24P4X Rear Panel
Figure 2-5 Rear Panel of SGS-6341-24T4X & SGS-6341-24P4X
■ AC Po
wer Receptacle
For compatibility with electric service in most areas of the world, the Managed Switch’s power supply
automatically adjusts to line power in the range of 100-240V AC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptacle on the rear panel of the Managed Switch. Plug
the other end of the power cord into an electric service outlet and then the power will be ready.
2.2 Installing the Managed Switch
This section describes how to install your Managed Switch and make connections to the Managed Switch.
Please read the following topics and perform the procedures in the order being presented. To install your Managed
Switch on a desktop or shelf, simply complete the following steps.
In this paragraph, we will describe how to install the Managed Switch and the installation points attended to it.
2.2.1 Desktop Installation
To install the Managed Switch on desktop or shelf, please follows these steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the Managed Switch.
Step 2: Place the Managed Switch on the desktop or the shelf near an AC power source, as shown in Figure 2-6.
1-17