SGS-6341-Series User Manual

User’s Manual of SGS-6341 series
Chapter 2 INSTALLATION
This section describes how to install your Managed Switch and make connections to the Managed Switch.
Please read the following topics and perform the procedures in the order being presented. To install your Managed
Switch on a desktop or shelf, simply complete the following steps.
In this paragraph, we will describe how to install the Managed Switch and the installation points attended to it.
2.1 Hardware Description
2.1.1 Switch Front Panel
The unit front panel provides a simple interface monitoring the switch. Figure 2-1 and Figure 2-2 show the front
panels of the Managed Switches.
SGS-6341-24T4X Front Panel
Figure 2-1 SGS-6341-24T4X front panel
SGS-6341-24P4X Front Panel
Figure 2-2 SGS-6341-24P4X front panel
■ Gigabit TP
Interface
10/100/1000BASE-T Copper, RJ45 twisted-pair: Up to 100 meters.
■ 10 Gigabit SFP Slot
10GBASE-SR/LR mini-GBIC slot, SFP (Small Factor Pluggable) Transceiver Module supports from 300
meters (Multi-mode Fiber), up to 10 kilometers (Single Mode Fiber)
■ Console Port
The console port is an RJ45 port connector. It is an interface for connecting a terminal directly. Through the
console port, it provides rich diagnostic information including IP address setting, factory reset, port
management, link status and system setting. Users can use the attached DB9 to RJ45 console cable in the
package and connect to the console port on the device. After the connection, users can run any terminal
emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm and so on) to enter the startup screen of
the device.
1-14