SGS-6341-Series User Manual

address. Switch supports static ARP configuration.
26.6.2 ARP Configuration Task List
ARP Configuration Task List:
1. Configure static ARP
1. Configure static ARP
Command Explanation
VLAN Interface Mode
arp <ip_address> <mac_address>
no arp <ip_address>
Configures a static ARP entry; the no
command deletes a static ARP entry.
26.6.3 ARP Troubleshooting
If ping from the switch to directly connected network devices fails, the following can be used to
check the possible cause and create a solution.
 Check whether the corresponding ARP has been learned by the switch.
 If ARP has not been learned, then enabled ARP debugging information and view
the sending/receiving condition of ARP packets.
 Defective cable is a common cause of ARP problems and may disable ARP
learning.
26-45
User’s Manual of SGS-6341 series
26.6.1 Introduction to ARP
ARP (Address Resolution Protocol) is mainly used to resolve IP address to Ethernet MAC
26.6 ARP