SGS-6341-Series User Manual

(2) Display and debug the informat
ion about configuration of redistribution of OSPF
routing to RIP
Command Explanation
Admin Mode
debug rip redistribute message send
no debug rip redistribute message send
debug rip redistribute route receive
no debug rip redistribute route receive
To enable or disable debugging messages
sent by RIP for redistribution of OSPF routing.
To enable or disable debugging messages
received from NSM.
7. Configure VRF address family mode for RIP
Command Explanation
Router RIP Mode
address-family ipv4 vrf <vrf-name>
no address-family ipv4 vrf <vrf-name>
The command configures a RIP address family
on the VRF of the PE router; the no command
deletes the configured address family.
Address Family Mode
exit-address-family
This command exits the address family mode.
26.4.3 RIP Examples – Typical RIP
Interface Interface
SWITCHB
vlan1:10.1.1.1/24 vlan1:10.1.1.2/24
SWITCHC
SWITCHA
Interface Interface
vlan2:20.1.1.1/24 vlan1:20.1.1.2/24
Figure 26-2 RIP
example
In the figure shown above,
a network consists of three Layer 3 switches, in which SwitchA
connected with SwitchB and SwitchC, and RIP routing protocol is running in all of the three
switches. SwitchA （interface vlan1：10.1.1.1,interface vlan2：20.1.1.1）exchanges Layer 3
switch update messages only with SwitchB（interface vlan1：10.1.1.2）, but not with SwitchC
（interface vlan 2: 20.1.1.2）.
SwitchA, SwitchB, SwitchC configurations are as follows:
a) Layer 3 SwitchA：
Configure the IP address of interface vlan 1
26-23
User’s Manual of SGS-6341 series