SGS-6341-Series User Manual

2. Configure RIP proto
col parameters (optional)
(1) Configure RIP sending mechanism
1) Configure specified RIP packets transmission address
2) Configure RIP interface broadcast
(2) Configure the RIP routing parameters
1) Configure route introduction (default route metric, configure routes of the other
protocols to be introduced in RIP)
2) Configure interface authentication mode and password
3) Configure the route deviation
4) Configure and apply route filter
5) Configure Split Horizon
(3) Configure other RIP protocol parameters
1) Configure the managing distance of RIP route
2) Configure the RIP route capacity limit in route table
3) Configure the RIP update, timeout, holddown and other timer.
4) Configure the receiving buffer size of RIP UDP
3. Configure RIP-I/RIP-II switch
(1) Configure the RIP version to be used in all interfaces
(2) Configure the RIP version to send/receive in all interfaces
(3) Configure whether to enable RIP packets sending/receiving for interfaces
4. Delete the specified route in RIP route table
5. Configure the RIP routing aggregation
(1) Configure aggregation route of IPv4 route mode
(2) Configure aggregation route of IPv4 interface configuration mode
(3) Display IPv4 aggregation route information
6. Configure redistribution of OSPF routing to RIP
(1) Enable Redistribution of OSPF routing to RIP
(2) Display and debug the information about configuration of redistribution of OSPF
routing to RIP
7. Configure VRF address family mode for RIP
(1) Enable/disable RIP module
(2) Configure VRF address family
1. Enable RIP protocol
Applying RIP route protocol with basic configuration in switch is simple. Normally you only
have to open the RIP switch and configure the segments running RIP, namely send and
receive the RIP data packet by default RIP configuration. The version of data packet sending
and receiving is variable when needed, allow/deny sending, receiving RIP data packet.
Refer to 3.
Command Explanation
Global Mode
router rip
no router rip
Enables RIP; the “no router rip” command
disables RIP.
26-17
User’s Manual of SGS-6341 series