SGS-6341-Series User Manual

 Make sure AC
L includes permit rule if the class-map matches ACL rule
 Make sure the switch exists enough TCAM resource to send the binding
Chapter 26 Layer 3 Management
Configuration
Switch only support Layer 2 forwarding, but can configure a Layer 3 management port for the
communication of all kinds of management protocols based on IP Protocol.
26.1 Layer 3 Management Interface
26.1.1 Introduction to Layer 3 Management Interface
Only one Layer 3 management interface can be created on switch. The Layer 3 interface is not
a physical interface but a virtual interface. Layer 3 interface is built on VLANs. The Layer 3
interface can contain one or more Layer 2 ports which belong to the same VLAN, or contain no
Layer 2 ports. At least one of the Layer 2 ports contained in Layer 3 interface should be in UP
state for Layer 3 interface in UP state, otherwise, Layer 3 interface will be in DOWN state. The
switch can use the IP addresses set in the Layer 3 management interface to communicate with
the other devices via IP.
26.1.2 Layer 3 Interface Configuration Task List
Layer 3 Interface Configuration Task List:
1. Create Layer 3 management interface
2. Configure VLAN interface description
1. Create Layer 3 Management Interface
Command Explanation
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
Creates a management VLAN interface; the no command
deletes the VLAN interface created in the switch.
2. Configure VLAN interface description
Command Explanation
VLAN Interface Mode
description <text>
Configure the description information of VLAN interface.
26-7
User’s Manual of SGS-6341 series